How to Solve the Problem of Generator Water Intake?
Updatetime:3/15/2019 3:55:30 PM Hits:
1. When the diesel generator is found to be in water, if the generator set is in operation, it will be shut down immediately, but it will not be allowed to start in the shutdown state.
2. Then one side of the diesel generator is lifted up with hard material, so that the oil discharging part of the engine oil pan is at the lowest position, the oil plug is rotated, and the oil scale is pulled out, so that the water in the oil pan can flow out by itself. When the oil is just about to be discharged, the oil and water should be slightly discharged together with a part of the back-spin top discharging plug.
3. Remove the air filter, replace the new filter element and immerse it in oil.
4. Remove the intake and exhaust pipes and mufflers below to remove the water in the pipes. Turn on the decompression and rotate the diesel engine to generate electricity. Observe whether there is water discharged from the intake and exhaust ports. If there is water discharged, continue to rotate the crankshaft until the water in the cylinder is completely discharged. Install the intake, exhaust pipe and muffler, add a little oil to the intake port, shake the crankshaft several times, and then install the air filter.
5. Remove the fuel tank and drain all the oil and water. Check whether there is water in the fuel system and drain it.
6. Discharge the sewage in the water tank and waterway, clean the waterway, add clean river water or boiled well water until the water float rises. Open the throttle switch and start the diesel engine. After starting the diesel engine, we should pay attention to observe the oil indicator rising and listen to the abnormal noise of the diesel engine.
7. Disassemble and develop the motor, check the stator and rotor inside the generator, then dry and assemble.
